Description

ER20 4 Pocket Premium

Patent Pending RapidChange ATC Magazines allow for the use of cutting tools with a maximum diameter of 30mm for ER20 collets and is designed for A Type clamping nuts.

The ER20 4 Premium Magazine is equipped with 4 tool  positions. It allows for safe unattended use by employing our innovative tool recognition sensor. It also includes a flexible clear vinyl cover that seals tight to the motor housings providing a good seal against dust and debris.

.The RapidChange ATC Magazine is machined from tough HDPE employing our unique patent pending spring loaded socket design. It works with your CNC and common spindle to allow smooth and reliable tool changes out of the box. Aside from a tool setter and the ability to run your spindle in reverse for unloading tools it can be used as a stand alone unit with no inputs or outputs required.

Macros for integrated motion control platforms as well as g code templates for writing your own macros can be downloaded from the website after purchase.

Dimensions for all magazine variations can be found HERE.
If you would like to check the fit on your machine we have mock up 3D models in .STEP format on our Discord Server for download.

Comprehensive installation Instructions to get you up and running quickly.

3D Probe Adapters for use with the supported 3D Probe allowing it to be used as a tool setter. You also have the option to utilize any external tool touch off device you prefer. 3D Probe NOT INCLUDED.

Dust Cover Control has changed for the better. The Premium Linear Magazine now uses servo motors to drive the dust cover through an output on the motion controller. If an output is not available on the controller a limit switch may be used to trigger the dust cover as the spindle moves over the magazine.

All the electronics are tucked nicely into the right end housing on the magazine.
12-24v is required and can be wired to the motion control board main power or a continuous aux power supply.

Red Power 12-24v input (36v upon request such as for a Onefinity Buildbotics controller )

Black Gnd. (If using a separate power supply that of the motion controller the they must share a common ground).

Blue Dust Cover signal wire is connected to an output on the motion controller active high.

Yellow IR signal wire is connected to an input on the motion controller active low.

Example Wiring Diagram