ER20-6 Premium (Copy)

ER20 6 Pocket Premium Magazine

The patent pending RapidChange ATC Magazines allow for the use of cutting tools with a maximum diameter of 30mm for ER20 collets and is designed for A Type clamping nuts.

The ER20 6 Premium Magazine is equipped with 6 tool  positions. It allows for safe unattended use by employing our innovative tool recognition sensor. It also includes a flexible clear vinyl cover that seals tight to the motor housings providing a good barrier against dust and debris.

This product is currently out of stock and unavailable.

Currency converter

Currency conversions are estimated and should be used for informational purposes only.

ER20-6 Premium (Copy)

SKU N/A Categories , Tag

Description

Linear ATC Magazine

Patent Pending RapidChange Linear ATC Magazines mount to the bed of your CNC.

Tool capacity for Linear magazines come in 3 sizes 4, 6 and 8 tool locations.

3D Probe Adapters are available sold separately for use with the supported 3D Probe allowing it to be used as a tool setter. You also have the option to utilize any external tool touch off device you prefer.

Dimensions for all magazine variations can be found HERE.  If you would like to check the fit on your machine.

Comprehensive installation Instructions to get you up and running quickly.

Currently Integrated Motion Control software
We have scripts and macros for the following products:
Centroid CNC12
Masso G3/G3 Touch
Onefinity Buildbotics
UCCNC
PlanetCNC
Mach3
Mach4
FluidNC
GrblHAL
LinuxCNC
Grbl (using Gsender)
WinCNC (under development)
Simple g code tool change files

The Basic Linear Magazine allows for safe unattended use by employing our innovative tool recognition sensor. The tool recognition sensor requires one input and is powered by 5v. A voltage converter sold separately can be used to allow input DC voltage up to 36v for easy integration. In most cases it can be wired to the motion controllers power supply.

The Premium Linear Magazine includes a flexible clear vinyl cover that seals tight to the servo motor housings providing a good seal against dust and debris. The dust cover control and tool recognition sensor is plug and play with our convenient controller interface module.

Plug and Play Interface Module requires just four wires which connect it to the motion controller.
Connect + & -, 12v-36v DC supply which can be shared with the motion controller. No need for an additional power supply.
One input on the motion controller for Tool recognition. For Grbl and Onefinity Buildbotics controllers, simply wire to the probe input.
One output on the motion controller for the controlling the dust cover.
Optionally a normally open mechanical or proximity type switch can be tied to an axis so as the axis moves over the magazine the dust cover will trigger to open.

 

The following is included with the complete magazine:
1 Base Magazine machined from tough HDPE.
A MEAN WELL RD-35B 5v-24v combo power supply for the IR sensor and the stepper driver.
5v IR sensor for tool recognition.
Dust Cover assembly with aviation connector and 6 meter cable.
M6 socket head cap screws for mounting the magazine.
2 Nema 17 stepper motors & 1 TB6600 stepper diver to drive the dust cover.
5v Interface Control Board allowing control via an available output pin on the motion controller (pulling the signal wire to Gnd will activate the dust cover to open).
It can also be controlled with a limit switch on one axis so that the dust cover opens as the spindle moves into position. Additionally it can also be wired in parallel to a rocker switch providing manual control even if used with an output pin.

Additional information

Weight 1.36 kg
Dimensions 46 × 10 × 10 cm
Collet Size

ER11, ER16, ER20

Reviews

There are no reviews yet.

Be the first to review “ER20-6 Premium (Copy)”

Your email address will not be published. Required fields are marked *